In article <4caeafe9$0$5098$c3e8da3$e5d14f71@news.astraweb.com>,
Blight@here.now says...
>On 07 Oct 2010 04:15:42 GMT, -=Blight=- <Blight@here.now> wrote:
>
>>Thanks for the upload, but your posting software bunged up the
>>images.
>>Even when I manually combine 1/2+2/2, the final image is always
>>586kb,
>>and I get error messages.
>>
>>In fact, your post doesn't even show up on Easynews' web interface.
>>I
>>went there when I ran into problems with my newsreader.
>>
>>Considering from above the images are all truncated at 586kb, is
>>there
>>a way to raise the part size in your uploader?
>>
>>++++++++++++++++++++++
>>
>>None of this is correct. The post was perfect, a few image errors,
>>if any. The problem is your side. NOT sandsoftime or Swarmer, as
>>using my provider I had no trouble.
>
>So you checked the Easynews web interface, and found those images?
>I'm
>impressed! :) They don't show up at all just listing by date, and
>whenn I search for sandsoftime or "girl with the far away eyes" I
>get
>NOTHING. That's obviously the fault of my newsreader, right?
>
>Yes, I use old software here, but that has not hing to do with the
>Newsreader host, now does it? :) If it were just my old reader, I'd
>just grab the images off the web interface, which is what I usually
>do.
>
>____________________
>
>Can you conprehend the fact that a problem with easynews, might very
>well be an issue on your side since MY provider, as well as the
>provider of the mentioned POSTER both had NO TROUBLE?
>
>DAMN!
>
The problem is with the format of the yEnc trailers at the end of
each multipart article. The posting software does not conform to the
yEnc "standard". Some decoders are robust enough to deal with the
problem, others aren't. You can use a stand-alone decoder like uudwin
The end of each multipart article looks something like this:
"=yend size=75228 part=0 pcrc32=2 crc32=5B9395BD"
The part=0 should be the part number of the article in question, not 0.
See http://www.yenc.org/yenc-draft.1.3.txt
The single part files have an invalid CRC32 at the end. SandsofTime
should use posting software that can actually post valid yEnc, or not
use yEnc with the software he has.
Customer Service
|
|