| 
 | https://en.wikipedia.org/wiki/Curtiss-Wright_XP-55_Ascender 
 The Curtiss-Wright XP-55 Ascender (company designation CW-24) was a 1940s United
 States prototype fighter aircraft built by Curtiss-Wright. Along with the Vultee
 XP-54 and Northrop XP-56, it resulted from United States Army Air Corps proposal
 R-40C issued on 27 November 1939 for aircraft with improved performance,
 armament, and pilot visibility over existing fighters; it specifically allowed
 for unconventional aircraft designs. A highly unusual design for its time, it
 had a canard configuration, a rear-mounted engine, swept wings, and two vertical
 tails. Because of its pusher design, it was sarcastically referred to as the
 "Ass-ender". Like the XP-54, the Ascender was initially designed for the Pratt &
 Whitney X-1800 engine and had to be redesigned when that engine project was
 cancelled. It was also the first Curtiss fighter aircraft to use tricycle
 landing gear.
 
 On 10 July 1942, the United States Army Air Forces issued a contract for three
 prototypes under the designation XP-55. Serial numbers were 42-78845 through
 42-78847. During this time, the Pratt & Whitney X-1800 H-block sleeve valve
 engine was experiencing serious developmental delays, and was eventually
 cancelled. Curtiss decided to switch to the 1,000 hp (750 kW) Allison V-1710
 (F16) liquid-cooled inline engine because of its proven reliability. Armament
 was to be two 20 mm (0.79 in) cannon and two 0.50 in (12.7 mm) machine guns.
 During the mock-up phase, it was decided to switch to the more powerful 1,275 hp
 (951 kW) V-1710-95. The 20 mm cannons were also replaced by 0.50 in machine
 guns.
 
 A special feature of the XP-55 was a propeller jettison lever located inside the
 cockpit to prevent the pilot from hitting the propeller during bailout. The
 jettison device was invented by W. Jerome Peterson while working as a design
 engineer for Curtiss-Wright.
 
 Role
 Fighter
 
 Manufacturer
 Curtiss-Wright Corporation
 
 First flight
 19 July 1943
 
 Status
 Cancelled at flight-test stage.
 
 Number built
 3
 
 The performance of the XP-55 was not very impressive and was often inferior to
 that of more conventional fighter aircraft already in service. In addition, by
 1944 jet-powered fighter aircraft were already well along in development and
 there was no further development of the XP-55.
 
 The third prototype XP-55 (s/n 42-78847) was lost on 27 May 1945 during the
 closing day of the Seventh War Bond Air Show at the Army Air Forces Fair at
 Wright Field in Dayton, Ohio. After a low pass in formation with a Lockheed P-38
 Lightning and a North American P-51 Mustang on each wing, its pilot, William C.
 Glasgow, attempted a slow roll, but lost altitude and crashed, sending flaming
 debris into occupied civilian ground vehicles on a highway near the airfield.
 The crash killed Glasgow and four civilians on the ground.
 
 Aircraft disposition
 
 
 
 
 loan from the Smithsonian's National Air and Space Museum in Washington, D.C..
 
 
 killed.
 
 Specifications (XP-55)
 
 General characteristics
 Crew: one pilot
 Length: 29 ft 7 in (9.0 m)
 Wingspan: 40 ft 7 in (12.4 m)
 Height: 10 ft 0 in (3.0 m)
 
 Empty weight: 6,354 lb (2,882 kg)
 Loaded weight: 7,710 lb (3,497 kg)
 Max. takeoff weight: 7,930 lb (3,600 kg)
 
 
 Performance
 Maximum speed: 390 mph at 19,300 ft (628 km/h)
 Range: 635 mi (1,020 km)
 Service ceiling: 34,600 ft (10,500 m)
 Rate of climb: 2,350 ft/min (11.9 m/s)
 
 Power/mass: 0.16 hp/lb (0.27 kW/kg)
 
 Armament
 
 
 
 
 
 
 *
 
 
 | 
 
 |